Next one is a hat with lots of cables: Cablino.
This one was lots of fun to sketch and watch those cables go smaller to shape the crown. It is often different from what you had in mind. But that makes it interesting.
It looks like some kind of flower, doesn’t it ?
It is worked bottom up and seamlessly in the round.
There is only one size due to the complexity of the cable design. But it is easy to alter the stitch gauge and thus obtain other sizes. Notes about changing gauge and size are included.
The cables are charted and written.
It can be worked as a beanie or blocked to a beret.
one size see below for other sizes
to fit head circumference: 54 – 58 cm / 21¼ – 22¾ “
finished measurement at the brim (slightly stretched): 52 cm / 20½”
crown circumference (blocked on a plate): 78 cm / 30¾” (diameter 25 cm / 9¾”)
Blocking aggressively will get a larger diameter.
Without blocking it is a beanie.
Top left is the unblocked beanie, the two other photos are the hat blocked to a beret.
What you’ll need
worsted / 10 ply
or you can use a fingering / 4 ply weight doubled
Yardage for the hat
± 210 m / 230 yards
(if you use fingering held double, you should double the yardage)
4 mm (US 6) circular needle
3 mm (US 2½) circular needle
23.5 sts and 32 rows of repeats of rows 1 to 24 of the cable stitch pattern, with the larger needle and blocked = 10 x 10 cm (4 x 4”)
a note on gauge and size
For a larger head circumference you will need a larger needle and aran weight at a gauge of 22 sts and 30 rows.
The finished measurement at the brim is 55 cm / 21½” and fits a head of 57 to 61 cm / 22½” to 24”
For a smaller head circumference you will need a smaller needle and DK weight at a gauge of 25.5 sts and 35 rows.
The finished measurement at the brim will be 48 cm / 19” and fits a head of 50 to 54 cm / 19½” to 21¼”
Check it out here